Home > News > Content

Open Utility Trailers Matters Needing Attention

May 10, 2017

Open utility trailers The correct operation of the trailer

1. Open utility trailers Locate the trailer hook at the rear of the tractor and the trailer in front of the trailer. Many car trailer hooks are designed in the lower part of the bumper, usually in the vehicle manual marked in a clear position, the owner can also be observed before and after the bumper hidden hidden space, where the use of circular or square cover Location is the location of the car trailer hook. The following are the same as the "

2. Open utility trailers Some car trailer hooks are split and need to be assembled when used. After removing the cover on the bumper, assemble the truck to carry the hook.

3. Open utility trailers Install the trailer tool. Whether it is the use of soft or hard trailer tool, the installation must ensure that the connection when the car hook firmly and reliably, the design of the hook on the safety lock need to lock in place. Check the front and rear connections again before the trailer travels. The three sides do not install the towel of the soft trailer rope in the use of bundled knot, if the death knot after a great traction pull will make the trailer rope is difficult to unlock.

4. Open utility trailers Tractor starting with a block to ensure that the big torque to provide adequate traction, while the tractor needs to control the speed, to maintain a smooth driving, when a slight resistance to increase the power output. Manual transmission models to avoid Meng Meng clutch pedal, the use of semi-linked slow start, so as not to cause damage to the car.

Open utility trailers Trailer precautions

1. Open utility trailers should choose the eyeful of eye-catching trailer tools, such as yellow, blue, fluorescent green, fluorescent red and so on. The color is not enough to hang the colored cloth on the trailer tool. Use the trailer rope or trailer lever with reflective material whenever possible to increase the warning effect.

2. Open utility trailers Trailer tools to be in the front and rear side of the vehicle trailer hook position to install, such as the fault car for the left hook, then the tractor should also choose the left hook to ensure that the road after the straight line. And in the installation of trailer hook must be checked afterwards to ensure that the trailer hook installed fastened, so as not to use the trailer hook in the process of playing out.

3. Open utility trailers pay attention to before and after the car communication with. Trailer has a lot of knowledge, which is very important between the front and rear drivers. Trailer drivers should be established between the reasonable driving routes, to avoid complex road conditions and congested sections. If there is no walkie-talkie as a communication tool, you need to put on the road before the start, slow down, turn, downhill and other operations of the communication signal, so before and after the car control.

4. Open utility trailers Control the safety distance. When using a trailer rope trailer to prevent the occurrence of rear-end, need to master the distance and speed. General trailer rope length of 5 ~ 10 m or so, so the car should be controlled within the effective range of the trailer rope to keep the trailer rope in tension. The speed of the trailer is controlled below 20 km / h.

5. Open utility trailers Before and after driving the vehicle should open the double flash warning light, along the outermost lane, you can also be tractor rear of the "trailer" logo indicate other vehicles carefully driving.