Home > News > Content

Trailer Need To Control The Speed, To Maintain A Smooth Driving

Jul 04, 2017

Locate the trailer hook at the rear of the tractor and the trailer in front of the trailer. Many car trailer hook position design in the lower part of the bumper, usually in the vehicle manual marked a clear position, the owner can also be observed before and after the bumper hidden hidden space, where the use of circular or square cover covered Location is the location of the car trailer hook.

2. Some car trailer hooks are split and need to be assembled when used. After removing the cover on the bumper, assemble the truck to carry the hook.

3. Install the trailer tool. Whether it is the use of soft or hard trailer tool, the installation must ensure that when connecting the car hook firmly and reliably, the design of the hook on the safety lock need to lock in place. Check the front and rear connections again before the trailer travels. The three sides do not install the towel of the soft trailer rope in the use of bundled knot, if the death knot after a huge traction pull will make the trailer rope is difficult to unlock.

4. Tractor starting with a block to ensure that the big torque to provide adequate traction, while the tractor needs to control the speed, to maintain a smooth driving, when a slight resistance to increase the power output. Manual transmission models to avoid Meng Meng clutch pedal, the use of semi-linked slowly start, so as not to cause damage to the car.

5. Trailer tools to be in the same side of the vehicle side of the trailer hook position to install, such as the fault car for the left hook, then the tractor should also choose the left hook to ensure that the road after the straight line. And in the installation of the trailer hook must be checked afterwards to ensure that the trailer hook installed fastened, so as not to use the trailer hook in the process of playing out.

6. Note the front and rear communication with. Trailer has a lot of knowledge, which is very important between the front and rear drivers. Trailers should be developed between the driver before the reasonable route, to avoid complex road conditions and congested sections. If there is no walkie-talkie as a communication tool, you need to put on the road before the start, slow down, turn, downhill and other operations of the communication signal, so before and after the car control.

7. Control the safety car distance. When using a trailer rope trailer to prevent the occurrence of rear-end, you need to master the distance and speed. General trailer rope length of 5 ~ 10 m or so, so the car should be controlled within the effective range of the trailer rope to keep the trailer rope in tension. The speed of the trailer is below 20 km / h.

8. Before and after driving the vehicle should open the double flash warning lights, along the outermost lane, you can also be tractor car behind the "trailer" logo indicate other vehicles carefully driving.